Customer need: consistent painting and added grinding

Lindner manufactures coffins and wanted more consistent finishing with surface grinding added to the line. Manual application can vary in speed, gun distance and coating thickness. The task was to translate finish requirements into suitable motion, application equipment and process control.

Paints, wood stains and patina bring different application requirements. The source does not publish a project start date or engineer visit schedule, so this record does not invent a dated installation timeline.

Configuration: separate painting and grinding robots

The robotic painting line has named equipment and distinct process roles. Those details make the case more useful than a general claim that automation improved production.

  • A FANUC P-250iB/15 six-axis paint robot handles the painting application.
  • A FANUC R-2000iC/125L six-axis robot handles surface grinding.
  • Each paint booth has two application systems, allowing high-pressure and low-pressure guns for different materials.
  • Confirm exact equipment options, certification and local requirements from the relevant documentation; one project is not a specification for every paint robot.

Implementation checks: separate material, motion and equipment

The manufacturer describes the configuration and goals, but not the full commissioning log. The following is technical guidance for a comparable line, not a reconstruction of undisclosed Lindner tests.

Start with the workpiece and coating material

Record part geometry, surface condition, material batch and the required finish. Check application conditions against the material supplier’s instructions. If material, sample or environment changes during a comparison, do not attribute every finish difference to the robot.

Check the gun and material supply

Verify gun type, nozzle condition, material delivery and atomization against the installed equipment instructions. Review filtration, cleaning and changeover conditions. A blockage, unstable supply or worn nozzle can affect the finish; changing motion alone may hide the symptom without addressing the cause. Parameters depend on the actual equipment and material.

Then check paths and the grinding process

Assess coverage, speed, gun orientation and distance against the workpiece. For grinding, check the tool, workpiece location and process consistency. Verify installed options before discussing force control or compensation; a robot model name alone does not establish what functions the cell uses.

Reported results: more monthly output with fewer shifts

FANUC reports monthly production increasing from 6,000 to 7,000 units while the schedule changed from three shifts to two. A Lindner production representative also describes improvements in working speed, ergonomics and product handling damage.

These are manufacturer-published customer results. The page does not give the full reporting period, product mix, utilization or investment return. They cannot establish the payback for another line or isolate the robot’s contribution from the rest of the process.

Additional acceptance workflow: safety, motion and finish

The following is Suntech’s planning guidance for robotic painting acceptance. Build the test plan around the actual equipment, material and site requirements.

  • Before startup: verify equipment identity, connections, program versions and the required site inspections.
  • Safety and interlocks: verify guarding, emergency stops, ventilation and process interlocks against applicable requirements before production trials.
  • Motion checks: in the prescribed commissioning mode, assess paths, coverage, part location, interference and alarms.
  • Process samples: record material, gun, supply, path and grinding conditions; assess samples against agreed finish or quality criteria.
  • Continuous operation: record accepted output, rework, cleaning, changeovers, stops and shifts with the measurement period and product scope.

Handover: preserve quality and capacity conditions

A useful line record links the customer need, installed configuration, operating conditions and acceptance results. Comparable products and defined reporting periods make production figures meaningful. For a coating problem, distinguish material, supply, gun and motion issues before selecting a maintenance or repair action.

Technical editing: Suntech Robotics Technology Limited. Customer: Lindner. Integrator: Wagner Service. Source: FANUC Europe.

Related reading: advantages and evaluation of automatic spray-painting systems

View painting robot services